The Hydro-Lift is a patented product of Filtra-Systems, which is used to pump cutting fluids and contaminates efficiently from floor level up 24" to 60" into a pumpstation or filter. The product was developed directly in response to the needs of customer with low machine discharges. The Hydro-Lift inlet is 3' above floor level and will operate effectively on any machine. The alternative, for machines with a discharge below 24", is to put the pumpstation in the floor, which is exactly what the customer is trying to eliminate.

The Hydro-Lift has been designed to run dry so it can operate anywhere from the peak machine discharge rate, down to no flow. It is capable of pumping any size turnings, chip bundles or swarf materials, which are transferred from the machine to the Hydro-Lift inlet. The Hydro-Lift pumps the cutting fluid and contaminates up into the side-mounted pumpstation. The pumpstation is fitted with a Chopper pump, which chops the chips fine enough so they can be pumped through overhead piping, to the filter, without plugging. The Hydro-Lift can also be directly side mounted to a filter when only one unit is required.