2002 Kent ERL-13X40 Engine Lathe #7559 #1 From estate sale. Very clean, barely used Kent lathe. Not sure why but has a Baldor 2 hp motor instead of 5 hp listed on specifications for this model. Does not have high / low switch either. So only 8 spindle speeds available currently. SPECIFICATIONS: Swing Over Bed: 13 3/8″ Swing Over Cross Slide: 8 1/4″ Swing Over Gap: 20″ Width of Bed: 9″ Distance Between Centers: 40″ Cross Slide Travel: 7″ Top Slide Travel: 4″ Spindle Speeds: 50 – 2,750 RPM (16 Steps) Through Hole Diameter: 1 9/16″ Spindle Nose: ASA D1-4 Camlock Spindle Bore Taper: MT # 5 Thread (Standard): 45 TPI Thread (Metric Pitch): 39mm Longitudinal Feed: 0.0016″ – 0.046″ Cross Feed: 0.001″ – 0.0375″ Lead Screw Diameter: 1 1/8″ Threading Pitch: 4 TPI Quill Travel: 4″ Quill Diameter: 2″ Quill Bore Taper: MT # 3 Motor: 5 HP EQUIPPED WITH: Face Plate (2) Chucks Aloris Tool Holder Steady Rest Tailstock Coolant