Gleason Hypoid Bevel Gear Tester Model# 512 Automatic tester S/N 702808 Machine was purchased from an Off-Highway customer whom had shut down their plant. Machine is in very good running condition and can be inspected under power in our shop. GLEASON 512 MACHINE SPECIFICATIONS CAPACITY Gear outside diameter (maximum).......................................508mm Pinion outside diameter (maximum).....................................254mm Offset of pinion spindle L or R of gear spindle center (max)........101.6mm PINION SPINDLE Diameter of taper hole at large end.................................3-29/32" Taper per foot........................................................39/64" Depth of taper............................................................3" Diameter of hole at small end.........................................3.740" Depth of hole at small end from face of spindle........................15.5" GEAR SPINDLE                                          Standard    Large Bore Diameter of taper hole at large end....................2-19/64".....3-29/32" Taper per foot.............................................1/2".......39/64"       Depth of taper...............................................3"...........3" Depth of hole at small end...............................2.168".......3.740" Depth of hole at small end from face of spindle..............8"...........7” Machine Is Equipped with the following  Safety Guarding when operating control pendant hydraulic clamping forward and reverse cycles hydraulic unit Electrical panel attached with operator pendant control This machine can be inspected under power with proper notice please contact us today to see this machine and other gear machines in our NC facility.