Chuck Size......................................36" 4-Jaw With Independant Jaws. Swing Side Head Above Table.....................36" Height Under Rail...............................30" Swing Side Head Below Table.....................38" Table Speed.....................................4.9 TO 180 Rpm's Feeds...........................................004 To .500 I.P.R. Feeds...........................................003 To .333 I.P.R. Turret Head Travel Left To Right................19.5" Turret Head Swivel..............................30 Degrees Turret Ram Head Turret Travel Up & Down.........34" Turret Head Position............................5 Side Head Travel In & Out.......................19" Side Head Travel Up & Down......................34" Main Motor......................................30 Hp. Floor Space.....................................R-L 120" X F-B 9'6" Height..........................................115" Weight..........................................36,000 Lbs. Power Elevation Of Rail.........................Yes Rapid Traverse To Both Head.....................Yes Built In 4 Way Tool Post On Side Head...........Yes Pendant Control.................................Yes Note: Reconditioning: Machine Will Be Cleaned, Painted And Cycled. 1. Turret Slide & Swivel in our facility. Dismantle unit as required. Clean all component parts. 2. Remachine all bearing surfaces of the Turret Slide to remove localized wear. 3. Remachine all bearing surfaces of the Turret Swivel to accept Turcite Way material. 4. Install Turcite to the Swivel and machine to correct height to compensate for material removed from Turret Slide. 5. Machine or grind oil grooves into swivel material for proper delivery of lubrication oil. 6. Block and hook frost all bearing surfaces of the turret slide for "pockets" for retention of lubrication oil. 7. Precision scrape and fit turret slide to swivel for proper bearing fit. 8. Manufacture new meehanite cast iron gibs for turret slide. Oil groove for proper delivery of lubrication oil. Precision scrape and fit allowing full range of adjustment to compensate for any future wear. These gibs will be the earless type. 9. Install triple lead downfeed screw and nuts. Install into nut body and realign to assure smooth and accurate operation. 10. Hang turret assembly in vertical position and reset turret locking mechanism for proper operation. Reset backlash eliminator to proper setting. 11. Cross-rail screws and nut will be replaced. 12. Turret and ram vertical screws and nuts replaced. 13. Main Shifting Solenoid Block Reconditioned / Rebuilt. 14. Hydraulics And Main Motor Will Be Reconditioned. New Belts New Oil And Filter. 15. All feed and rapid shafts seals will be replaced. Hand wheel seals will be replaced, gear boxes will be cleaned and checked. Machine should be ready to ship in about 20 to 24 weeks after receipt of PO. Price will be $99,500.00 after reconditioning. Optional: Chuck Size 36" 3-Jaw Scroll With Independant Jaws.$16,500.00