18" X 26" WATERBURY FARREL 2 HI ROLLING MILL Stock # 14344 MANUFACTURER: WATERBURY FARREL CORPORATION (USA) TYPE: 2 HI REVERSING ROLLING MILL FOR FLAT SHEET OR ROD/BAR ROLL SIZE: 18" (457MM) DIAMETER X 26" (660MM) WIDTH DRIVE MOTOR: 300 HP, 600/1500 RPM, 1000 AMPS, 250 VOLT TOSHIBA D.C. GEARBOX: PHILADELPHIA MFG. (USA) WITH 32.5 TO 1 GEAR RATIO ROLLING SPEED: 0 - 200 FPM (0 - 60 M/MIN) SCREWDOWNS: MOTORIZED WITH TWO 7-1/2 HP, 540/1620 A.C. MOTORS ROLL BEARINGS: ROLLER PASS LINE HEIGHT: 49" (1244 MM) HOUSING CROSS SECTION: 16" (406 MM) X 13" (330 MM) MAXIMUM ROLL OPENING: 7.5" (190 MM) ELECTRICAL CONTROLS: -MANUFACTURER: SABINA ELECTRICAL ENGINEERS (USA) -UPGRADED AND INSTALLED IN 2006 -TYPE: SCR THYRISTOR DRIVE -INPUT: 230 VOLTS, 1200 AMPS, UP TO 400 HP, 3 PH, 60 HZ. -OUTPUT ARM VOLTS: 250, 130 AMPS -OUTPUT FIELD VOLTS: 250, 13.5 AMPS MILL IS INSTALLED AND FULLY OPERATIONAL LOCATED IN USA INCLUDES: -THREE SETS OF ROD/BAR ROLLS -ONE SET OF FLAT SHEET/STRIP ROLLS -ENTRY DRIVEN ROLLER TABLE 12.5 FT. (3.8 M) -EXIT DRIVEN ROLLER TABLE (12.5 FT. (3.8 M) -DRAWINGS (APPROX. 100) MILL IS AVAILABLE FOR INSPECTION WITH APPOINTMENT **Temporary Specifications Subject to Revisions** **PRICE QUOTED AS IS WHERE IS SUBJECT TO PRIOR SALE** **ALL SPECIFICATIONS ARE SUBJECT TO BUYERS VERIFICATION**