Swing over bed from 50 inch to 80 inch
Centre distances available up to 40 ft.
Hollow spindles from 6 inches to 32 inches.

BED
Width (W/O auxiliary guide) mm (in.) 1100 (43.30)
Width (W auxiliary guide) mm (in.) 1270 (50.00)
CARRIAGE
Cross slide travel(Long carriage) mm (in.) 1170 (46.06)
Cross slide travel(Short carriage) mm (in.) 415 (16.33)
Compound tool post travel mm (in.) 600 (23.62)
4-way tool post width mm (in.) 310 (12.20)
THREAD FEED RANGE
Longitudinal feed mm/rev (in.rev) 0.045~2.55 (0.0018~0
Cross feed mm/rev (in.rev) 0.023~1.28 (0.0009~0.05)
Longitudinal rapid feed mm/rev (in.rev) 2000 (78.74)
Cross rapid feed mm/min (in/min) 1270 (50.00)
Metric thread mm (kinds) 1~56 (60)
Inch thread TPI (kinds) 1/2~28 (60)
Module thread MOD (kinds) 0.25~14 (60)
Diamteral pitch thread DP (kinds) 2~112 (60)
Pitch of leadscrew mm (TPI) 12 (2)
TAILSTOCK
Quill diameter mm (in.) 235 (9.25)
Quill travel mm (in.) 200 (7.87)
Inner taper of quill MT#6
Bearing surface on the bed ways mm (in.) 660 (25.98)
MOTOR
Main spindle motor KW (HP) 29(40)-STD.
37(50) / 44(60) / 55(75) / 74(100) / 11(150) / 149(200)-OPT
Coolant pump motor
KW (HP) 0.37 (0.5)
Note :
(1) X and Z axes actual cutting diameter will change when equipped with different turrets.
(2) Specifications are subject to change without notice for improvement

STANDARD ACCESSORIES
* 1 dead centre, MT #6.
* 2-speed tailstock quill (manual).
* One piece stainless steel leadscrew cover.
* Coolant pump.
* Follow type splash guard.
* Rear side chip and water collect plate.
* Thread chasing dial.
* Water and oil collect plate under apron.
* Work lamp.
OUTSTANDING FEATURES
* One piece bed, floor type casting.
* 4 shear bed way with dual way centre guide plus front lateral way for carriage support under cutting.
* All ways are hardened and ground.
* Alloy steel spindle with opposed taper roller bearings.
* Hardened and ground gears, shafts.
* Electromagnetic spindle brake.
* Variable spindle speeds in 4 automatic ranges through pneumatic shifting.
* 6-way rapid traverse and power feed to top slide.
* Totally enclosed universal inch / metric gear box.
* Carriage position device.
* Dual voltage spindle motor, 40 to 100 HP.
* Pressurized one shot lube system for cross slide and carriage.