Processing Machine Specifications Machine structure: X/Y Precision Rack & Pinion - Z=precision ball screw Travel drive method: X-Y-Z simultaneous 3 axes (Z-axis height control is also possible) Maximum workpiece size: 120.1 x 60.0 Table pass height: 34.6 Processing access: Automatic up/down door Pallet changer: Provided X-axis stroke: 122 Y-axis stroke: 61 Z-axis stroke: 5.9 Rapid travel speed (X,Y) inches per minute: 3940/5550 simultaneous Maximum processing federate, inches per minute: 1970 Positioning precision: 0.0019/20 (X,Y), 0.0039/4 (Z) Drive motor type: Intelligent AC servo Maximum workpiece weight: 2050 lbs. Control system Specifications: CPU: 64-bit Display screen: 15" TFT color LCD touch screen Hard disk: 20.0 GB Generator output control: Output power, frequency, duty Generator operation control: Beam on/off, laser gas charge, etc. Drive system: X,Y,Z simultaneous control Position detection system: Encoder Minimum command input: 0.001 mm / 0.001" Program input system: USB Computer Link, ethernet LAN Pallet Changer Specifications: Drive mechanism: Chain Pallet change time (Sec.): Approximate 30 Work clamps: 2 sets on Y Axis Pallet capacity: 2050 lbs. Applicable machine size: 3015 (5' x 10') CO2 Laser specifications- 45CF-R Excitation method: 3-axis cross flow, silent discharge Maximum output power: 4500-watts Rated output power: 4500-watts Control method: Power feedback Power stability: Less than +/- 1 % of rated power Beam mode: Low-order Beam outer diameter: 1.02 Beam divergence (mrad): Approximately 3.5 of less total angle Las gas composition (CO2:CO:N2:He): 8:4:60:28 Laser gas consumption rate (liter/hour): 24 during continuous oscillation Wave length: 10.6 microns Frequency setting range: 10~3000 Hz Duty range: 0~100 percent adjustable Output power adjustable range: 0~100 percent Equipped with: Chiller Dust Collector