60" Chuck W/ 6" chuck life left, 36" Stone Cutting Head, Head Quick Tilt, Motor Percent Load Meter, Wheel Dresser (Manual), Neutrofier Remote Control, Coolant Pump & Tank, Point of Operation Enclosure Door, COMPLETE FACTORY SAFETY GUARDS, Master Start/Stop Buttons, Spindle Start/Stop Buttons, Table Start/Stop Buttons, Down Head Feed Start/Stop Buttons, Head Up/Down Buttons, Carriage In/Out Buttons, Coolant Off/On Switch, Head Flat Tilt Switch, Variable Feed Rate Dial, Table Traverse handwheel,

CHUCK: (Electro-Magnetic) Diameter 60" (1,524mm) R.P.M Infinitely Variable thru 28 Actual Swing- 66" GREATEST SWING INSIDE WATER PAN, 73½" (1,866.9mm) GRINDING WHEEL: Segmental Type, Diameter 32" (812.8mm) GRINDING WHEEL ASSEMBLY: Vertical Movement 30" (762mm) By (Handwheel and Power) WHEEL HEAD FEED RATE: Variable Automatic 0.005" thru 165" per/min. (0.127mm thru 4,191 per/mm) Pre-determined 0.001" thru 240" per/min. (0..0254mm thru 6,096 per/mm) MOTOR DRIVES: wired 460 volts 3-phase Stone 125 hp (91.94kw) 230/460 volts Chuck Rotation Hydraulic Drive 5 hp. (3.7kw) 230/460 volts Carriage Head Vertical Feed Up/Down 3 hp. (2.2kw) 230/460 volts Motor Cooling Fan ¾ hp. (0.55kw) 230/460 volts Coolant Pump 1½ hp. (1.103kw) 230/460 volts CONTROLS: Controls Wired 115 volts Master Start/Stop Buttons, Spindle Start/Stop Buttons, Table Start/Stop Buttons, Down Head Feed Start/Stop Buttons, Head Up/Down Buttons, Carriage In/Out Buttons, Coolant Off/On Switch, Head Flat Tilt Switch, Variable Feed Rate Dial, Table Traverse handwheel Approx Dimensions- 8' x 17' x 171 Coolant Tank Dimensions- 4' x 10'