* One piece bed, floor type casting.
* 2 shear bed way with extra way supporting the apron.
* All ways are hardened and ground.
* Alloy steel spindle with opposed taper roller bearings.
* Hardened and ground gears, shafts.
* Electromagnetic spindle brake.
* 18-speed geared headstock.
* 6-way rapid traverse and power feed to top slide.
* Totally enclosed universal inch / metric gear box.
* Carriage position device.
* Dual voltage spindle motor, 20 to 50 HP.
* Pressurized one shot lube system for cross slide and carriage.

STANDARD ACCESSORIES
* 1 dead centre, MT #6.
* 2-speed tailstock quill (manual).
* One piece stainless steel leadscrew cover.
* Coolant pump.
* Follow type splash guard.
* Rear side chip and water collect plate.
* Thread chasing dial.
* Water and oil collect plate under apron.
* Work lamp.
SPECIFICATIONS
BED
Width (W/O auxiliary guide)
mm (in.)
715 (28.14)
Width (W auxiliary guide)
mm (in.)
800 (31.49)
CARRIAGE
Cross slide travel
mm (in.)
800 (31.49)
Compound tool post travel
mm (in.)
500 (19.68)
4-way tool post width
mm (in.)
255 (10.03)
THREAD FEED RANGE
Longitudinal feed
mm/rev (in.rev)
0.045~2.55 (0.0018~0.1)
Cross feed
mm/rev (in.rev)
0.023~1.28 (0.0009~0.05)
Longitudinal rapid feed
mm/rev (in.rev)
2000 (78.74)
Cross rapid feed
mm/min (in/min)
1270 (50.00)
Metric thread
mm (kinds)
1~56 (60)
Inch thread
TPI (kinds)
1/2~28 (60)
Module thread
MOD (kinds)
0.25~14 (60)
Diamteral pitch thread
DP (kinds)
2~112 (60)
Pitch of leadscrew
mm (TPI)
12 (2)
TAILSTOCK
Quill diameter
mm (in.)
145 (5.70)
Quill travel
mm (in.)
200 (7.87)
Inner taper of quill
MT#6
Bearing surface on the bed ways
mm (in.)
600 (23.62)
MOTOR
Main spindle motor
KW (HP)
22(30)-STD.
29(40) / 37(50)-OPT.
Coolant pump motor
KW (HP)
0.1 (0.125)
Note :
(1) X and Z axes actual cutting diameter will change when equipped with different turrets.
(2) Specifications are subject to change without notice for improvement