EDGE TECHNOLOGIES PATRIOT 551 AUTOMATIC BAR LOADER FULL 6' BAR CAP, NEW 2011 CAN LOAD UP TO 8'BARS, 42mm CHANNEL INSTALLED   Equipped with: Configured with a 42mm Channel Set (additional channel sets can be purchased. Price on request)   New Replacement $38,000   Originally on an Okuma Genos L400, should configure to almost all CNC Turning Centers   Specifications: Capacity . . . . . . . . . . . . . . . 2" Bar Length . . . . . . . . . . . . . . 8" Length of Spindle Type . . . . . . . . No Synch for Sliding Headstock . . . . . .No Axial Shift . . . . . . . . . . . . . .No Dimensions . . . . . . . . . . . . . . 128" x 28" x 49" Weight . . . . . . . . . . . . . . . . 2,200 lbs.   To the best of our knowledge all details listed below are deemed correct. It is the buyer's responsibility to confirmed prior to purchase.   General Specifications per Manufacturer   Bar Capacity:    No Prep:                         5mm to 44.5mm (.196" to 1.75")    With Prep:                       5mm to 51 mm (.196" to 2.000") Maximum Bar Length:                 8' Minimum Bar Length:                 39.4" Maximum Remnant Length:             16" Magazine Rack Capacity:             12" Bar Loading Cycle:                  30 seconds for 12' bar Material Straightness Specifications:.007"TIR/ft of material                                      (V Blocks, 3 points equidistant) Feed Force (pusher torque):          max 450N, adjustable Foward Feed Rate:                    750 inches/min max, adjustable Return Feed Rate:                    1000 inches/min max, adjustable Power Consumption:                   1.5kW Operating Voltage:                   230V/60 Hz - 3 phase Control Voltage:                     24V DC Oil Capacity:                        57 liters (15 gallons) Oil Viscosity:                       ISO 150cST Compressed Air Supply:               6 bar (90 psi) Compressed Air Consumption:          approx. 8 liters/loading cycle   Barfeed: 133" x 28" x 49" 2,100 lbs   To the best of our knowledge all details listed below are deemed correct. It is the buyer’s responsibility to confirm all details and we encourage an inspection of the machine(s) and accessories prior to purchase.     FOR MORE INFORMATION: Call Mike at 973-497-7540