SOUTHWESTERN INDUSTRIES / PROTO-TRAK 3- AXIS CNC VERTICAL MILL MODEL: K2SX-3, S/N: 092CM62560, NEW: 2009   SPECIFICATIONS: TABLE WORKING SURFACE ............... 9" X 49" TRAVELS: LONGITUDINAL (X) ........... 33"          CROSS (Y) .................. 12"          VERTICAL, KNEE ............. 16"          QUILL (Z) .................. 5" QUILL DIAMETER ...................... 3.375" MAXIMUM UNIFORM TABLE LOAD .......... 750 LBS. RAM TRAVEL .......................... 12" HEAD TILT, LEFT AND RIGHT ........... 90 DEGREES HEAD TILT, FRONT TO REAR, EACH WAY .. 45 DEGREES SPINDLE SPEEDS INFINITELY VARIABLE:       LOW RANGE ..................... 60 - 500 RPM       HIGH RANGE .................... 500 - 4,200 RPM SPINDLE TAPER ....................... R-8 MAXIMUM COLLET CAPACITY ............. 3/4" MAXIMUM RAPID FEED RATE ............. 100 IPM APPROX DIMENSIONS ................... 70"W X 57"D  X 84"H APPROX WEIGHT ....................... 2300 LBS   EQUIPPED WITH - PROTOTRAK MODEL: SMX 3 THREE-AXIS (X,Y & Z) CNC CONTROL   (THREE-AXIS DIGITAL DISPLAY IN MANUAL MODE)    ADVANCED FEATURES, NETWORKING & TRAKING - LCD SCREEN, PRECISION BALL SCREWS AND SERVO DRIVES FOR EACH AXIS - PROGRAMMABLE ELECTRONIC HEAD FOR SPINDLE SPEED & TAPPING - TRAKING/ELECTRONIC HANDWHEELS OPTION - MACH-1 QUICK CHANGE TOOLING SYSTEM w/TOOLS - MEEHANITE CASTING - HARDENED AND GROUND DOVETAIL WAYS ON SADDLE - HARDENED AND GROUND DOVETAIL WAYS ON X-AXIS (LONGITUDINAL) AND KNEE - SLIDE WAYS ARE TURCITE COATED - AUTOMATIC LUBRICATION SYSTEM - 3 HORSE POWER SPINDLE DRIVE MOTOR AND ELECTRICAL CONTROLS   INSPECT UNDER POWER IN OUR NEW JERSEY WAREHOUSE FOR MORE INFORMATION: Call David at 973-497-7570