Cutting&slitting machine with stationary web system.
The web feed is run down to full stop for cutting and then accelerated again.

One side of feed table guides is fixed, other adjustable by hand wheel to match the coil width. The 4 upper straightener shafts are adjustable on the operator side using hand-wheels with scales. The 5 lower shafts are adjusted with screws on the unit body. The slitter is driven via roller chain by the pull unit motor. The locating and fixing of blades is manual. The guillotine has two sided blades. It can be built operating with either stationary web or as “flying cut-off” system.
Servo-drives for all operations – straightening, pulling, slitting and cutting. All electrical components are in one single electric cabinet. Controls from separate control panel.