Goose neck die-holder for punching different profile sections on legs and webs. It also allows for the quick changing of punches and dies, with the die holder being easily adjusted in order to align tools. The punching table comes complete with scales. Angle shearing for round and square bars, without any loss of material. Shearing system for flat bars and plates with minimum deformation and a very sturdy table marked out with degrees for an easy setup of non-square cuts. Two material guides are also included. Rectangular notching including a gauge table with scales. This station is also suitable for Pipe and Tube Notching, Rectangular Notching, Secondary Punching Station or for special shape Notching. The permanent bending station is compliant with CE standards with a moving speed of 3/8” per second and a foot pedal that stops movement when pushed too hard. The lower die is held in place in a pocket and is easily removed. The station has Standard Die V openings of 2” and 3-3/8”. It also allows for a micrometer fine adjustment of the depth stroke to improve repeatability.

BENDICROP 50 FEATURES AND SPECIFICATIONS FEATURES BENDICROP 50 Punching Power 55 US Tons Punching Ø 1-1/16” x 1/2″ Shearing flat bars 14 x 3/8″@ 2º 14 x 1/2″@4º Shear of angle section L at 90 3” x 3” x 5/16 Bending 4” x 3/8” with 2 “V” dies of 1-5/8” and 2-3/4” Openings Rectangular Notching Thickness 3/8” Width of Notcher 1-9/16” Depth of Cut 3/8” Round and Square Bar Shearing Ø1-3/8” Ø 1-3/16” Square