Swing Over Bed Ways.........................................39" Swing Over Cross Slide......................................26" Swing In Gap................................................56" Length Of Gap...............................................17" Center Distance.............................................100" Spindle Hole................................................16-1/4" Spindle Speeds .............................................7 To 315 Rpm's Chuck Size With 16-1/4" Hole Front..........................32" 4 - Jaw Chuck Size With 16-1/4" Hole Rear...........................32" 4 - Jaw Feeds Cross ................................................0.0025 To .069IPR Feeds Long .................................................0.101 To 1.30 IPR Threads Inch................................................1/2 To 56 TPI Threads Metric .............................................4 To 11 TPI Tail Stock Quill Diameter...................................4" Tail Stock Quill Travel1....................................10" Tail Stock Taper ...........................................# 5 Morse Floor Space Length & Width .................................R-L 206" X F-B 96" Machine Height..............................................69" Weight......................................................29,000 Lbs. Main Motor..................................................40 Hp. Steady Rest.................................................15" Taper Attachment ...........................................Yes Thread Dial.................................................Yes 4-Way Rapid Traverse........................................Yes Coolant / Chip Pans (Will Be Made Prior To Shipping) Note: Machine ways and saddle have been ground and refitted. Cross slide reworked. Machine was never put back in service after work was completed. Machine will be cleaned & painted prior to shipping.