ACRA 1400TE Precision Engine Lathe, 5 HP, 14 3/16" Swing; 40" Centers; 2.063 Thru Hole, 70-1,800 RPM (8 speeds). ACRA’s 1440TE Precision Gap Bed Engine Lathes are made in Taiwan and feature the following: Bed & Stand: One Piece Cast Iron Floor Stand With Foot Brake Front Removable Chip Tray Floor Stand Or Rear Chip Floor Stand Selected Bed Width (10-1/4″), Bed Meehanite Casting, Vibration Stress Relieved Induction hardened And Precision Ground Bed Ways Precision Hand Scraped Removable Gap Bed Headstock: Dynamic Balanced Spindle Spindle Is Supported By 3 Points Precision Bearings-2 Taper Roller And 1 Ball Bearing Housing Are Properly Stabilized & Deflection Free All Gears & Shafts Are Made By Chromium Molybdenum Steel With Segmentation And Precision Ground EVS Models Forced Lubrication System Nylon Safety Gears In End Train Spindle: Machined From Forged Alloy Steel, Hardened Ground & Dynamically Balance Three Point Support By High Grade Precision Machine Tool Taper Roller & Ball Bearings Universal Gear Box: Induction Hardened And Ground Gears And Shafts Wide Threads Cutting Capacity For Imperial, Metric, Module Pitch And Diametrical Pitch Apron: Right Hand Side Or Left-Hand Size Apron. Hand-Wheel Available As Requested Integrated Automatic Device For Longitudinal & Cross Feeds, Forward And Reverse Feeds Carriage & Slide: Anti-Float Design, Backlash Eliminator Fitted In Cross Slide Nut Safety Clutches At Feed Shaft Lever Dual Reading Dials One Shot Lubrication For Carriage And Tops Slide STANDARD EQUIPMENT 8" 3-Jaw Chuck 10" 4-Jaw Chuck Steady/Follow Rest Halogen Light Coolant System 4 Way Tool Holder Full Length Splash Guard Chuck Guard ADDITIONAL OPTIONS AVAILABLE