Geka Hydracrop 110 Ironworker Machines 2 Cylinders Hydraulic ironworker machine with 2 working areas and 5 workstations. FEATURES Two independent working cylinders, one for the punch and one for the shear Two remote foot pedals Mitre cuts angles on 45° leg-in Large single cut, no-slug-loss, "non-deform" angle cut Large "non-deform" plate shear capacity, low rake on blade Easy to adjust length of stroke Ram keyed for shaped tooling Quick change punch holder Adjustable swing away stripper Structural die holder for punching beams and channels in the flange Deep punch throat 20" Jog control Round and square bar blades 3" and 4" channel shear blades Rectangular coper or V-notcher Plate shear support table with mitre guides East to adjust blade gap Safety lock-out for the coper/notcher station Machine prewired for electric automatic length gauge Easy access to the hydraulics (front and back) Geka Hydracrop 110 is an ironworker machine for punching, shearing, notching and angle, square and round bars cutting tasks. It can be managed by two workers at the same time thanks to its two cylinders. As a result, Geka Hydracrop 110 will save time and increase the efficiency of the user when working with its ironworker. Geka Hydracrop 110 is part of Geka´s two-cylinder Ironworker machines series called Hydracrop. The five workstations of this ironworker machine are the following: Punching Angle shearing Flat bars shearing Bars cutting Notching

FEATURES GEKA HYDRACROP 110/180 Punching Power 120 US Tons Punching Ø1-1/2″ x 3/4″ Ø1-3/32″ x 1-3/32″ Shearing Power 180 US Tons Shears of Flat Bars and Plates 24″ x 5/8″ 16″ x 3/4″ Shearing of Angles (without deformation) 6″x6″x1/2″ Shearing of Solid Round and Square Bars (Optional Blades) Ø 2″ and □ 2″ Rectangular Notching 3-1/2″ x 2″ x 1/2″