Chuck Dia.: No Specs Attached inches Spindle (Horz/Vert): No Specs Attached Power: No Specs Attached horsepower Swing: No Specs Attached inches Under Wheel: No Specs Attached inches Grinding Wheel Width: No Specs Attached inches Grinding Wheel Dia.: No Specs Attached inches CNC Control: No Specs Attached Type of CNC Control: No Specs Attached Dimensions: No Specs Attached Weight: No Specs Attached ounces Table Speeds: No Specs Attached Table Motor Horsepower: No Specs Attached horsepower Spindle Motor: 15HP, 240/480 voltRange: 20" Diameter x 9" Vertical over ChuckChuck: 20" Diameter,Chuck Speeds: 15, 24, 41, 64 RPMGrinding Wheel:New Cortland Segmented Chuck and ClampsGrinding Wheel Speed: 1200 RPMFeeds: .003 - .070 IPMAutomatic lube systemsStandard Coolant System (Paper Filtration system available)Floor Space: 5'3"L x 3'6"W x 6' 8-3/4"Max./5' 9-1/2"Min.HApprox. Weight: 7200 lbs The scope of work is as follows:  Clean up electrical (Replace a could overloads) Replace Coolant Lines Replace Water Guards Clean and Paint Tram Head to Table Test Run for 8 Hours.