SPECIFICATIONS: Workhead Swing Over Main Slide – Maximum…………12″ Workhead Collet Hole – Maximum…………1-1/4″ Workhead Collet Hole – Minimum…………0.12″ Grinding Wheel Diameter – Maximum…………4″ Lead Generation by Spiral Lead Mechanism – Minimum…………1-13/16″ Lendth of Work Between Spindle & Tailstock Center…………6″ Workhead Main Slide Travel (L-R)…………6-3/4″ Workhead Offset Slide Travel – Total (F-B)…………5-1/2″ Workhead Front of Center…………3″ Workhead Read of Center…………2-1/2″ Workhead Turntable Swivel…………235 Degrees Workhead Above and Below Center…………+/-40 Degrees Wheelhead Slide Travel – Longitudinal (L-R)…………6-1/4″ Wheelhead Slide Travel – Vertical…………10-1/2″ Wheelhead Above Center…………4-1/2″ Wheelhead Below Center…………5″ Cross Slide Travel (F-B)…………7-1/2″ Cross Slide Front of Center…………3″ Cross Clide Rear of Center…………4-1/2″ Wheelhead Spindle Speeds (3)…………4000-5729-8000 RPM Wheelhead Motor…………1/2 HP Workhead Spindle Speeds…………0 – 850 RPM (Variable) Dimensions – Approximate…………54″(L-R) x 56″(F-B) x 65″(H) Weight – Approximate…………1,850 Lbs. EQUIPPED WITH: Baldor DC Drive Workhead, Variable Speed Controller Precision Ball-Screws in All Axis One-Shot Lubrication System Set of Grinding Wheel Guards Grinding Wheelhead Toothrest & Extension Bar Adjustable Tail-Center Support Diamond Bracket w/Workrest Lower Workrest *Preliminary specifications subject to verification.