Available gauges listed below 7020 In-Active Pressure Gage 15 psi Pressure 7020-01 In-Active Pressure Gage 15 psi Pressure 7020-02 In-Active Pressure Gage 15 psi Pressure 7020-03 In-Active Pressure Gage 15 psi Pressure 7020-04 In-Active Pressure Gage 15 psi Pressure 7020-05 In-Active Pressure Gage 15 psi Pressure 7020-06 In-Active Pressure Gage 15 psi Pressure 7020-07 In-Active Pressure Gage 15 psi Pressure 7025 In-Active Conductivity/PPM Meter Conductivity 7030 In-Active Main Controller Thermometer 7040 In-Active Ultrasonic Washer Ultrasonic Washer 7050 In-Active Thermometer w/ Probe Thermometer 7050-10 In-Active Tank Thermometer Thermometer 7060 In-Active Digital Timer Digital Timer 7117 In-Active Copper Sulfate Test Part Copper Sulfate Test Specimen

The Model E992 Automated Passivation system is equipped with an E992 ultrasonic washer and (4) 60-gallon heated storage tanks (HST's). These are designed for alkaline cleaning solution, acid passivation solution and rinse water. Pump filter systems are incorporated into the HST's. This system is designed to run automated cycles of alkaline cleaning, rinsing, passivation, rinsing and drying. The system uses high powered ultrasonics for cleaning and agitation during the steps of the program. Storage Tank #1 (Acid) is designed to acid passivation solution Storage Tank #2 (Alkaline) is designed to hold alkaline cleaning solution Storage Tank #3 (Rinse #1) is designed to hold rinse water Storage Tank #4 (Rinse #2) is designed to hold rinse water Highly powered ultrasonics are used for the cleaning/passivating/rinsing agitation. If ultrasonics are not desired during cleaning or passiveation steps, they can be turned off during these steps for soaking only. 4,500 watts of heat and 1,100 cfm of air are used for the drying cycle of the program. A Beijer HMI panel mount interface is included with the E992 unit allowing monitoring of the on-line operation and modifying of the program.