To the best of our knowledge all details listed below are deemed correct. It is the buyer’s responsibility to confirm all details and we encourage an inspection of the machine(s) and accessories prior to purchase. General Specifications: Please pay attention to details below, read carefully. Main Voltage: 480 VAC / 3 Phase Full Load Amps: 20 Amps Frequency: 60 Hertz Circuit Breaker Amperage Rating: 25 Amps Short Circuit Rating: 5 KA Motor Power: .5 HP Control Voltage: 120 VAC / 24 VDC Clean, Dry, Oil Free Compressed Air: 75 Peak SCFM @ 80 PSI, 23 Ave. SCFM Vacuum Exhaust: 400 CFM @ 2" (wg) SP Deionized Water: 2-3 GPM Flow Rate @ 40-80 PSI Clean & Rinse Tank Temp: 170 Degrees F Drain: Clean and Rinse Tanks Clean Liquid Filter (X-110-A): 30" 10 Micron Poly Core. Poly Wound #1. Cleaning Station Work area: 14”DOT X 23”FB X 14”D (31 GALLON TANK) Overflow weir - one sided, saw toothed Drain Insulated Electric Heat: with controller to heat from ambient to 160 degrees F in 3 hours Ultrasonics: • 2000W, 25kHz, sidemounted high efficiency immersible transducer arrays with dedicated solid state generators • 2000W, 40 kHz, bottommounted Agitation Filter/Sparger System: stainless steel sparger (skims surface to separate overflow weir), single chamber cartridge filter, air diaphragm pump Spray over Immersion: dual parallel sidemounted spray headers to provide spray over immersion #2 - Hot Rinse Station with Spray over Immersion Work area: 14”DOT X 23”FB X 14”D (24.3 GALLON TANK) Overflow weir - one sided, saw toothed Drain Insulated Electric Heat: with controller to heat from ambient to 160 degrees F in 3 hours Agitation Spray over Immersion: dual parallel sidemounted spray headers to provide spray over immersion. Customer supplied water Air Blow off: 2 side mounted air knives above the spray off. Customer supplied air Ultrasonics: 2000W, 40kHz bottom mounted PLC: Allen Bradley microprocessor with touch screen operation. Instant Hot Water Heater: 36 kW- * Sandvik to Plumb and Wire Hot Water Heater Note: Pump Module to Drain (this unit is not needed if buyer has a drain in close proximately to the back of the system. It is available if needed, requires air for diaphram pump & level control (* Pump to Drain Module is approx 24: from the back of the machine but can be plumbed to be further away or change of direction to take up less floor space. Shipping dimensions: Machine: 56" x 79"x 87" 3000 lbs ?? Pallet w/tray/filter/collector: 49" x 55" x 46" 800 lbs Table: 36" x 30" x 36" 150 lbs