· Modern CNC control: Data input and set-up mode are effected via operator in direct dialogue. Programming language is interchangeable from German to English. Data carrier software allows data input and output via a serial interface. · Continuous generating gear grinding method: Automatic grinding cycle, including automatic re-profiling of the grinding wheel on the machine. Shift grinding device: During the grinding process the workpiece is constantly shifted tangentially across the grinding wheel. · Machine was modernized by BURRI Company approx 10 years ago with an electronic controlled V-Axis for generating the lead on the worm wheel without any change gears, all profile modifications can be effected easily, that reduces a lot of idle times ! Built on motorized single diamond disc dressing device SP-DR with some diamond tools. · Also the A-Axis is DC-motorized to swivel the Workpiece/Helix angle, CNC controlled, · Built-on hydraulically swivelling sensor for automatic positioning of the grinding wheel in the tooth gap. This saves a lot of time. · DITTEL Grinding Wheel Balancing Device. · Hydraulic workpiece clamping with centres and counter centres in the worpiece slide. · Fully covered working area with oil mist exhaust, two sliding doors…there is no original Coolant device available, we may have a separate Coolant oil separator available. · Separate switch and control cabinet. * Separate hydraulic unit. Some Grinding wheel flanges.

Gear Ø, min./max. 10 - 330 mm Module 0.5 - 7 Helix angle +/- 45 ° Max. Workhead stroke 180 mm No. of teeth 10 - 600 Max. Clamping Length of Workpiece 420 up to 620 mm Max. weight of workpiece 60 kg Grinding worm Ø x width 350 x 84 – 104 mm Speed of Grinding Worm 1.100 to 1.900 rpm Spindle Drive 4 kW, total electrical load, approx. 12 kW - 400 V - 50 Hz Weight, approx. 8,500 kg