Model Features • DXF, DWG Direct Import • Adjustable water height on water table • Low backlash 5:1 gearboxes Standard Equipment • Water table, Gantry, and Arc Voltage Height Control • Full cable carrier system • Visual Machine Designer Touchscreen Interface Construction • Steel fabricated gantry with dual y-axis drive • Precision x-axis linear guide—the ultimate in accuracy and durability • Precision ground y-axis guide rails to within .001 tolerances, 63 Micro finish, custom made in the USA Electronics/Motion System • Two Y-axis 380 oz. in. stepper motors • One X-axis 380 oz. in stepper motor • 8 amp micro stepping drives • Motion Controller User Controls • Burny PHANTOM II Weight • Approximately 4,739 lbs for 6’ x 22’ system with no water Input Power • Torchmate X machine requires 15 amp/ 110 volt AC service of 8amp/220v AC service Input Air • 8 SCFM @ 90 PSI, dry air filtered to minimum 5 micron Cutting Area • 6'x22' Cutting Capacity • 275 AMP Drive System • Rack and pinion X/Y-Axis 5:1 Reduction • Ball Screw/Linear Stage Z-Axis Traverse Speed • Up to 572 ipm Cut Speed • Up to 572 ipm Standard Software • SIGMANEST